G161z head

[als tg g180]

I have a fully worked G161z head oversize inlet and exahust valves, matched ported, polished and flowed. Has lightend cam caps and comes with a big arse crow cam RPM 3400rpm-7400rpm really lumpy. The only thing it needs is alloy rockers, twin side draft webbers or EFI set up with a turbo or supercharger.

[F|sh]

have you got figures?

PM me if willing to send to WA

[als tg g180]

I was looking at $400 plus postage and handling well worth to get all the work that has been done your looking at over $1000 to do all the work that has been done to it. Have drove it with a std G161z block with the head with a 1 mill thick head gasket and it was a screamer very lumpy cam. When the cam kicks in it started to lift the front wheels it was grounded for a rally car.

[F|sh]

so what valves does it run and springs too.

Sounds reasonable. get some quotes and i'll give a address.

[gemrocket]

hey mate do u still have this head?? so there nothen at all wrong with it i need to good head 4 my worked g180