Page 1 of 1
G161z head
Posted: Thu Aug 24, 2006 10:01 am
by als tg g180
I have a fully worked G161z head oversize inlet and exahust valves, matched ported, polished and flowed. Has lightend cam caps and comes with a big arse crow cam RPM 3400rpm-7400rpm really lumpy. The only thing it needs is alloy rockers, twin side draft webbers or EFI set up with a turbo or supercharger.
Posted: Thu Aug 24, 2006 4:06 pm
by F|sh
have you got figures?
PM me if willing to send to WA
Posted: Fri Aug 25, 2006 10:01 am
by als tg g180
I was looking at $400 plus postage and handling well worth to get all the work that has been done your looking at over $1000 to do all the work that has been done to it. Have drove it with a std G161z block with the head with a 1 mill thick head gasket and it was a screamer very lumpy cam. When the cam kicks in it started to lift the front wheels it was grounded for a rally car.
Posted: Fri Aug 25, 2006 1:14 pm
by F|sh
so what valves does it run and springs too.
Sounds reasonable. get some quotes and i'll give a address.
Posted: Sun Jan 14, 2007 5:18 pm
by gemrocket
hey mate do u still have this head?? so there nothen at all wrong with it i need to good head 4 my worked g180